FAQ's

Frequently Asked Questions

 

Can I leave my BOAT MATE® in the water all boating season?

  • Absolutely! Attach it to the dock and simply remove it at the end of the season. A helpful tip to extend its life is to give it a wipe down when needed throughout the season.

How much do I inflate the Boat Mate®?

  •  We recommend inflating your Boat Mate® between 1-2 psi. You will want to allow some room for expansion for when temperatures rise, (you should be able to depress the BOAT MATE® approximately 1/2 inch with your thumb.) If you use the pump supplied, 100 manual pumps should inflate the Boat Mate® perfectly.

 

What size of boats can be used with the BOAT MATE®?

  • The Boat Mate® will protect watercraft up to 24' long with a single bumper. For larger applications, use 2 BOAT MATES® connected end to end with the stainless steel D rings.

 

How do I clean the bumper?

  • Lukewarm water and a mild detergent is all you need with a soft cloth.

 

What happens if I get a hole in my BOAT MATE®?

  • Each BOAT MATE® comes with a repair patch if it happens to accidentally tear.

 

Is the BOAT MATE® safe to step on?

  • BOAT MATE® is not intended to use as a step and we've indicated that by putting a "No Step" symbol on each end for everyone's safety.

 

Can BOAT MATE® be used in salt water?

  • Yes, however we recommend cleaning monthly to protect it from any harsh elements.

 

Does the BOAT MATE® have a cover?

  • No, we have found that a cover or “sock” actually accumulates dirt and debris and can end up scratching your boat.

 

Is there a specific way to moor or tie up the BOAT MATE®?

  • For best results, and to prevent stress on the D-Ring patches, the Boat Mate® ropes must be perpendicular to the boat mate and dock. Do not attach any ropes at less than a 90 degree angle. (Anything less will put an unnecessary strain on the D-Ring connection and possible cause detachment).